Expansion Module for IP Phone 1100 Series (SIP Firmware)User GuideTitle page
Regulatory and safety information10
Introduction11IntroductionThis document describes the Expansion Module for IP Phone 1100 Series (SIP Firmware) and how to use it with the IP Phone.Des
Introduction12Figure 1: IP Phone 1100 Series Expansion Module FeaturesThe Expansion Module has the following features:• The IP Phone 1140E and IP Phon
Introduction13Attention: If the phone is powered using PoE (Power over Ethernet), the backlight of the expansion modules is disabled.• The Expansion M
Introduction14Adjusting the expansion module display screen contrastTo adjust the expansion module screen contrast, press the Prefs Context-sensitive
Introduction15Expansion Module, the IP Phone should be powered by AC global power supply only.IconsThe Expansion Module supports the same icons and ca
Setup and assembly16Setup and assemblyThe Expansion Module mounts on the right side of the IP Phone. The Expansion Module snaps into the Accessory Exp
Setup and assembly171. Press the tilt lever to adjust the stand angle on the IP Phone. You can adjust the stand angle to maximum, instead of removing
Setup and assembly18Figure 3: Connecting the Expansion Module4. If connecting a second, or a third Expansion Module, repeat steps 2 to 4.Attention: T
Setup and assembly19Expansion Module startup initializationOnce the Expansion Module has been installed and powered up on the IP Phone, the Expansion
Setup and assembly20Table 2 lists the initialization process for the Expansion Module.Table 2: Initializing Expansion ModulePhase DescriptionExpansion
Setup and assembly21Using the wall-mount optionIP Phone and Expansion Module combination can be wall-mounted using the wall mount template provided.Ad
Expansion Module programming22Expansion Module programmingWhen an Expansion Module is installed on an IP Phone, the controls and settings of the IP Ph
Expansion Module for IP Phone 1100 Series (SIP Firmware)User GuideCopyright © 2008 Nortel Networks. All rights reserved.LEGAL NOTICEWhile the informat
Revision history3Revision historyJune 2008Standard 01.07. This is a new user guide for the SIP Firmware IP Phone 1100 series Expansion Module.
Revision history4
Contents5ContentsRegulatory and safety information . . . . . . . . . . . . . . . . . . . . 7Other . . . . . . . . . . . . . . . . . . . . . . . . .
Contents6
Regulatory and safety information7Regulatory and safety informationThis equipment has been tested and found to comply with the limits for a Class B di
Regulatory and safety information8To prevent radio interference to the licensed service, this device must be operated indoors only and should be kept
Regulatory and safety information9DenAn regulatory notice for Japan
Comments to this Manuals