Nortel Networks 400-S User Manual download pdf (Page 69)

Chapter 7 Out-of-band management support 69

Setting Up the BayStack Instant Internet 400-S Unit

6 From the Bits per second list, select 115200 to set the modem speed, and then

click OK.

HyperTerminal establishes a connection to the Instant Internet unit. If the

Instant Internet unit is password protected, the session begins by requesting a

password. Enter the password for the Instant Internet unit and then press

Enter.

When you successfully log on, the command prompt is displayed (Figure 11) and

you can begin using remote access commands to configure the unit.

Figure 11 Command prompt

Configuring the Instant Internet unit through a dial-up

connection

To configure the unit through a dial-up connection using the out-of-band

management feature, you must:

• Connect the modem to a PC.

• Use a terminal emulation software application to configure the modem

connection settings.

• Connect the modem to your Instant Internet unit.

Note: If you enter an incorrect password, the message “Incorrect

You are given two more chances before Instant Internet ends the session

and disconnects you.

BayStack Instant Internet(tm) version 7.11

ii>

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 85 86

No comments

Nortel Networks 400-S User Manual Page 69