Chapter 3 Instant Internet 400-S hardware installation 43
Setting Up the BayStack Instant Internet 400-S Unit
Table 5 shows the voltage selector switch settings for the different voltage ranges.
Instant Internet quick installation
These steps guide you through the general process of installing your Instant
Internet hardware.
Install your Instant Internet 400-S unit in a ventilated area that is dust free and
away from heat vents, warm air exhaust from other equipment, and direct
sunlight. Avoid proximity to large electric motors or other electromagnetic
equipment. Be sure to choose a location near your router and LAN or WAN hubs
and close to an electrical outlet.
The communications connection is necessary to provide the link between your
Instant Internet unit and your Internet service provider (ISP). To ensure a proper
communications connection, make sure that you have ordered the appropriate
following services:
• Installation from your telco
• Service from your telco
• Internet access service from your ISP
Be sure to review the information in “Installation checklist” on page 31.
Table 5 Voltage selector switch settings
Setting Voltage range
115 For voltages between 100 and 127
230 For voltages between 200 and 240
Caution: Before you begin installation, make sure that the power voltage
selector switch matches your power voltage (see “Setting the voltage
selector switch” on page 42) and the DIP switch settings are set to normal
operation (see “Switch settings for normal operation” on page 56).
Comments to this Manuals