Nortel Networks NN43001-563 User Manual Page 192

  • Download
  • Add to my manuals
  • Print
  • Page
    / 492
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 191
192 Install and configure IP Trunk 3.01 (and later) node
2
Remove any existing I/O panel cables associated with any card
previously installed in the selected card slot.
3
Install the NTWE07AA DCHIP PC Card into the internal PC Card slot
on the IP trunk card that has been selected to provide the DCHIP
function. (See Figure 34 "DCHIP PC Card and NTCW84EA pigtail
cable" (page 192) on Figure 34 "DCHIP PC Card and NTCW84EA
pigtail cable" (page 192).)
4
Connect the NTCW84EA pigtail cable from port 0 of the DCHIP PC
Card to the J14 pin header on the motherboard of the DCHIP card.
See Figure 34 "DCHIP PC Card and NTCW84EA pigtail cable"
(page 192).
The cable routes the D-Channel signals to the backplane and the I/O
panel. The PC Card connector is keyed to allow insertion only in the
correct direction. The J-14 pin header connector is not keyed. Be
careful to align the connector with the pin header.
Figure 34
DCHIP PC Card and NTCW84EA pigtail cable
5
Pull the top and bottom locking devices away from the IP trunk card
faceplate. Insert the IP trunk card into the card slots and carefully
push it until it makes contact with the backplane connector. Hook
the locking devices.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright © 2007, Nortel Networks
.
Page view 191
1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 491 492

Comments to this Manuals

No comments