Part No. 893-00994-AMay 1997 Reference for the Centillion 1008/2-port EtherSpeed 10BASE-T/100BASE-FX Switch Module 893-00994-A Page 1 Tuesday, Ap
2 Introduction The Centillion 100 EtherSpeed 10BASE-T/100BASE-FX Switch Module from Bay Networks ® inserts into one slot of a Centillion 100 ™ ch
3 Status LEDs Two banks of status LEDs on the EtherSpeed module correspond to the port numbers on the module (see Figure 2). Each fiber port has a cor
4 Default Configuration Table 2 lists the factory defaults for ports on the EtherSpeed module. Table 2. Factory defaults for EtherSpeed 10/100 Mb/s
5 UTP Port Requirements The RJ-45 connectors for the 10BASE-T ports accept standard unshielded twisted pair (UTP) cable and are wired as MDI-X ports
6 Technical Specifications Network Protocol and Standards Compatibility IEEE 802.3 for 10 Mb/s portsIEEE 802.3u for 100 Mb/s ports Data Rate 100 Mb/
7 Environmental Specifications Operating temperature: 0 ° to 40 ° CStorage temperature: –25 ° to 70 ° COperating humidity: 85% maximum relative hu
8 Declaration of Conformity The following Declaration of Conformity for the Centillion 100 8/2-port EtherSpeed 10BASE-T/100BASE-FX Switch Module id
© 1997 by Bay Networks, Inc. All rights reserved. Trademarks Bay Networks is a registered trademark of Bay Networks, Inc. Centillion 100, EtherSpeed,
Comments to this Manuals