Nortel Networks 210667-A User Manual

Part No. 210667-ADecember, 20004401 Great America ParkwaySanta Clara, CA 95054210667-AInstalling the e-mobility 802.11b Wireless LAN DSSS Access Point

10e-mobility 802.11b Wireless LAN DSSS Access Point AntennasAntenna coverage is analogous to lighting. Users might find an area lit from far away to b

11The standard antenna performs well in most office environments. Obtain additional or higher-performance antennas from Nortel Networks. Contact a Nor

12Connecting the Power AdapterThe power adapter connects to the rear of the access point and to a power outlet.To connect the power adapter:1 Verify t

13LED IndicatorsThe LED indicators provide a status display indicating transmission and error conditions. The indicators are:Power Flashing indicates

14SpecificationsPhysical Characteristics:Dimensions 1.25 inches H x 5.5 inches L x 7.75 inches W (3.18 cm H x 14.97 cm L x 19.69 cm W)Weight (w/power

15Radio Characteristics:The frequency range used by the e-mobility 802.11b WLAN DSSS components is within 2.4 GHz to 2.5 GHz unlicensed ISM band. From

16Radio Data Range 11 Mbps range Open environment - approximately 400 feet (121.92 meters)Typical office or retail environment - approximately 150 fe

17

2Copyright © 2000 Nortel NetworksAll rights reserved. Printed in the USA. December 2000.The information in this document is subject to change without

3The conformity assessment procedure referred to in Article 10(5) and detailed in Annex IV of Directive 1999/5/EC has been followed with the involveme

4EN 55 022 StatementThis is to certify that the Nortel Networks e-mobility 802.11b Wireless LAN DSSS Access Point is shielded against the generation o

5Règlement sur le brouillage radioélectrique du ministère des CommunicationsCet appareil numérique (e-mobility 802.11b Wireless LAN DSSS Access Point)

6How To Get HelpIf you purchased a service contract for your Nortel Networks product from a distributor or authorized reseller, contact the technical

7IntroductionThe e-mobility 802.11b Wireless LAN DSSS Access Point (AP) provides a bridge between Ethernet wired LANs and e-mobility wireless networks

8Network ConnectionLocate connectors for Ethernet, antennas, and power on the back of the AP. Ethernet configurations vary according to the environmen

9Mounting the APThe AP rests on a flat surface or attaches to any hard, flat, stable surface. Position the AP at any angle. Use the standard-mounting