Nortel Networks 5000I User Manual download pdf (Page 37)

Network Installation{ XE "Scanner, 5000i:Network

configuration" }

The 5000i scanner in a network configuration requires an NCS Pearson-supplied computer,

monitor, keyboard, mouse and required networking equipment. An optional printer may also be

installed.

tiger001

Figure 3 – 3: Network Connection

Computer

This section discusses installation and internal cabling for the computer{ XE "Network

installation:Computer" } in a network configuration.

Installation

Before installing the computer in the scanner, do the following.

1. Use your fingers (or a screwdriver) to remove the screw (knurled knob) at the rear of the

computer (center-top) and lift off the cover. Some models have green plastic covered

screws, and some have two screws. Some models have green plastic covered screws, and

some have two screws.

CAUTION: Use ESD precautions (including a grounded wrist strap) for

steps 2, 3, and 4.

2. Make sure that the scanner interface cards and all ribbon cables are fully seated.

3. Remove the Catgut board from its separate packaging and do the following:

• Ensure that the three 40-pin DIP and one 40-pin SIP headers that connect the Catgut

II board to the Catgut I board are fully seated.

Chapter 3. Computer and Peripherals Installation Page 25

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 53 54

No comments

Nortel Networks 5000I User Manual Page 37